Thinking about tools when I am going to tooling.
　I try to consider about tools when I am going to one day or two day trip. What tools should be brought? W650 already equipped tools but I don't like to use it, the parts might be damaged. W650 spoke wheeler has a tube inside the tire has risk of stuck by puncture, I have to prepare the tube repair kit and air pump etc before the trip...
　I want to bring the compact baggage but at the same time I should correspond to any considerable case. The following picture is shown my selected tools for the short trip. The way of thinking is that be able to repair puncture front and rear tire, to loosen and tighten the mainly bolts, nuts and screws. I don't have confident that those tools whether are enough, probably never use that tools. But If I have prepare those tools, makes needless worry about any troubles...
Short trip tools
　1 Cotter pin (for rear wheel axle)
　2 Patch for a puncture repair (3sizes)
　3 Case for the sandpaper, patch and tape
　4 Rubber cement
　5 Tire cream (For the easy attaching and detaching of the tire. Protect the tire and wheel from injury)
　6 spare tube for rear tire
　7 Extension bar
　8 Wheel rim protector
　9 Combination wrench
10 Tire lever
11 Spinner handle
12 Ratchet handle
13 Socket wrench 10/12/14/16(for spark plug)/17/19/27(for rear axle)
14 Hex socket wrench 12mm(2piece for front wheel axle shaft)
15 Water pump plier
16 Air pump
17 Cutter knife
18 Minus bit screw driver
19 Plus bit screw driver No.2 and No.3 size
20 Hex wrench 3/5/6mm
21 Minus bit screw driver for the adjustment of pilot screw on the carburetor
22 Tape
23 Sandpaper
24 Valve seal remover for the tire tube
W650 Top Page